Iceriver KS3M KS3L ASIC Chip Tin Tool for P2SG48 Chip Hashboard repair

Iceriver KS3M / KS3L ASIC Chip Tin Tool | High-Temperature Composite Fixture for P2SG48 Hashboard Chip Replacement

The Iceriver KS3M / KS3L ASIC chip tin tool is a chip-level rework fixture for the P2SG48 ASIC chip used on KS3M and KS3L hashboards. Built from a high-temperature-resistant composite outperforming standard alloy materials in heat tolerance and wear life — survives the repeated 220–250°C reflow cycles a busy repair bench imposes on a stencil.

Paired with a steel mesh featuring precise hole positions that map 1:1 to the P2SG48 chip pad array. The tight pattern matters: misaligned apertures cause bridging on dense Kaspa-mining ASIC footprints, killing chains on first power-up. The mesh also provides anti-static protection during placement, eliminating the charge-buildup damage that shows up days later as random hash drops.

When You Need This Tin Tool

• Replacing a failed P2SG48 ASIC chip on a KS3M / KS3L hashboard after chain-level diagnostics.
• Re-tinning chip pads after lifting a dead ASIC — restores even pad geometry for the next reflow.
• Salvaging working chips from a scrap KS3M / KS3L board for reuse on a recoverable hashboard.
• Bench throughput improvement — consistency and speed over freehand iron-tinning on the dense P2SG48 footprint.

Iceriver KS3M / KS3L Tin Tool Specifications

FAQ — P2SG48 Tin Tool

Q: KS3M vs KS3L — same tool for both?
A: Yes. Both hashboards use the same P2SG48 ASIC chip footprint; the stencil fits both. The miners differ in chip count and hashrate but share the chip-pad geometry.

Q: Hot air station profile?
A: Bottom-side preheat 130–150°C, top-side hot air 320°C with a controlled ramp matching the solder paste manufacturer's profile. Preheat the entire board before applying top-side heat — the dense aluminum substrate of the KS3M / KS3L pulls heat away fast and skipping preheat causes uneven reflow.

Q: How many cycles before the stencil needs replacing?
A: The composite material handles repeated reflow without warping. Clean with IPA between every cycle — dried paste in the apertures is the actual end-of-life trigger, not heat fatigue. Replace if the apertures clog or the mesh frame deforms.

Q: Bulk pricing for Iceriver repair benches?
A: Yes — email contact@lys-sz.com for set pricing on Iceriver chip-rework tooling.

Related products

• Iceriver KS1 / KS2 / KS3 / KS3M / KS3L / KS5L / KS5M Control Board
• Iceriver KS3M / KS3L Water Cooling Plate Kit
• Iceriver 4-pin Fan Simulator (KS3 / KS3M / KS3L / KS5L)
• Iceriver KS5L / KS5M Water Cooling Plate Kit

Iceriver KS3M / KS3L repair benches stocking P2SG48 tin tools by the set? Email contact@lys-sz.com for bulk pricing. Worldwide shipping from our Shenzhen warehouse.