Antminer S19XP+ Hydro Water Cooling Plate – Original Cooling Block for 279T / 293T

Antminer S19XP+ Hydro Water Cooling Plate | Original Aluminum Cooling Block Replacement for 279T / 293T Bitmain Hydro Miners

The Antminer S19XP+ Hydro Water Cooling Plate is the original factory-spec aluminum cooling block for the Bitmain Antminer S19XP+ Hydro miner family. Direct replacement when the OEM cooling plate fails — typical failure modes include corrosion-induced micro-leaks, deformation under sustained thermal cycling, or impact damage during handling. Restores the rated thermal performance and keeps the hashboards stable at full hashrate.

Compatibility covers the S19XP+ Hydro 279T and 293T variants — same cooling-plate footprint across both hashrate bins. Constructed from aerospace-grade aluminum alloy with laser-cut internal channels and vacuum brazing for the seal joints — three processes that together give the plate the dimensional precision, internal-flow uniformity, and leak-proof construction needed for sustained hydro mining duty.

When to Replace the Cooling Plate

• Visible coolant leak from the cooling block — micro-crack or corrosion through the brazing joint, immediate replacement.
• Hashboard junction temperatures climbing at unchanged coolant flow — internal channel scaling or partial blockage, plate degraded.
• Physical damage from handling — bent fittings or surface dents that affect mating to the hashboard.
• S19XP+ Hydro throttling under sustained load with the rest of the cooling loop healthy — cooling plate at end-of-life.
• Routine fleet refurbishment — replace cooling plates during full miner teardown to extend service life.

Antminer S19XP+ Hydro Cooling Plate Specifications

FAQ — S19XP+ Hydro Cooling Plate

Q: Does this plate fit both the 279T and 293T variants?
A: Yes — the S19XP+ Hydro family uses the same cooling plate across the 279T and 293T hashrate bins. The hashrate difference comes from chip binning, not from a different mechanical or thermal footprint. One replacement plate covers both.

Q: DN10 interface — what coolant fittings should I use?
A: Standard DN10 (10mm OD) hydro fittings. Use the OEM hose clamps and double-seal quick connectors from the rest of your Antminer hydro infrastructure. Don't mix different ID hoses — flow restrictions cause hot spots on the hashboards.

Q: Can I use this plate with non-OEM coolant?
A: Stick with the recommended distilled water + corrosion inhibitor mix that Bitmain specifies. Off-spec coolants (tap water, glycol mixes outside the recommended ratio) accelerate internal corrosion and shorten cooling-plate life.

Q: Bulk pricing for hydro fleet refurbishment?
A: Yes — email contact@lys-sz.com for case-quantity S19XP+ Hydro cooling-plate pricing.

Related products

• Antminer S21 Hydro Water Cooling Heatsink Plate
• Antminer S19K Pro Water Cooling Plate
• Double Seal Quick Connector (ASIC hydro tubes)
• Lian Li 12kW Hydro ASIC Water Cooling Kit

Hydro farm operators stocking S19XP+ Hydro cooling plates by the case? Email contact@lys-sz.com for bulk pricing. Worldwide shipping from our Shenzhen warehouse.