D100N06ESL 100A 60V N-channel MOSFET for ASIC Miner PSU
Couldn't load pickup availability
Have questions about this product? Our team is here to help — just reach out on WhatsApp.
💬 Contact Us on WhatsAppAbout the Product
D100N06ESL N-Channel MOSFET 100A / 60V | Low-Rdson Replacement for ASIC Miner PSU Output Stage Repair
The D100N06ESL is a 100A continuous / 60V N-channel MOSFET in DFN5x6 package, sized for the output stages of ASIC miner power supplies. Ultra-low 3.5mΩ Rdson means minimal conduction loss at full PSU current — the PSU stays cooler, runs more efficiently, and survives longer under the continuous near-full-load duty cycle that mining PSUs see.
Direct drop-in replacement when an original output MOSFET fails. Failed MOSFETs typically present as a PSU that won't start, that trips on overcurrent, that delivers an out-of-spec output, or that has visibly burnt components on the output stage. The D100N06ESL fits Bitmain APW series, Whatsminer PSUs and third-party 60V-class mining power supplies that use the same package and electrical envelope.
When to Replace the D100N06ESL
- PSU won't power on after a fault — output MOSFET failed short or open, primary controller refuses to start.
- Overcurrent trip on startup — short across the output MOSFET drawing the primary side into protection.
- Output voltage drift outside spec — degraded MOSFET on one phase pulling the regulation off, replace and verify.
- Visible burn marks on the output stage — direct replacement, swap all parallel MOSFETs in the affected leg.
- Preventive PSU refurbishment — replace output MOSFETs proactively during a rebuild on used APW or Whatsminer PSU units.
D100N06ESL MOSFET Specifications
| Parameter | Specification |
|---|---|
| Part Number | D100N06ESL |
| Type | N-Channel power MOSFET |
| Drain-Source Voltage (Vdss) | 60 V |
| Continuous Drain Current (ID) | 100 A |
| On-Resistance (Rdson max) | 3.5 mΩ |
| Package | DFN5×6 |
| Mounting | SMD reflow |
| Typical Application | ASIC PSU output stage, synchronous rectification, load switching |
| Weight | ~1 g per unit |
| Condition | Brand New |
FAQ — D100N06ESL MOSFET
Q: Why does Rdson matter so much for PSU MOSFETs?
A: ASIC PSUs push 200A+ across the output stage continuously. Each milliohm of Rdson dissipates ~I²R watts per MOSFET — at 100A that's 35W per part for a 3.5mΩ device. Doubling the Rdson doubles the heat. Low-Rdson parts run cooler and last longer.
Q: Can I substitute a different 60V N-channel MOSFET in the same package?
A: Generally yes if the substitute has equal or lower Rdson and equal or higher current rating in the same DFN5×6 footprint. Verify thermal envelope and gate threshold before substituting — gate drive mismatches cause oscillation.
Q: Should I replace all MOSFETs on the failed leg or just the dead one?
A: For best long-term reliability replace all paralleled MOSFETs on the affected leg — the surviving parts have absorbed the thermal stress of the failure event and have shortened life expectancy.
Q: Bulk pricing for repair shops?
A: Yes — email contact@lys-sz.com with your monthly volume. Reel and tray quantities are stocked.
Related products
- NCEP60T18 60V N-Channel MOSFET – ASIC PSU
- NTMFS4C09NT1G 30V 52A MOSFET – Avalon PSU Repair
- Si7N65F 650V MOSFET – Antminer APW17 / APW12 PSU
- NTMFS5C430NL Single N-Channel Power MOSFET
Repair shops stocking D100N06ESL MOSFETs by the reel? Email contact@lys-sz.com for bulk pricing. Worldwide shipping from our Shenzhen warehouse.
Buying in bulk for a mining farm or repair shop?
Get dedicated B2B pricing on this part and across our full catalog — quote response within 24 hours, payment by T/T USD bank wire, and DDP delivery available for US & EU customers (and other lanes on request).
