Whatsminer Power Cord C19 to EU Plug 16A 250V 3x2.5mm - 1.5m

Whatsminer Power Cord C19 to EU Plug | 16A 250V 3x2.5mm Copper for European Mining Mains Connection

The Whatsminer C19 to EU plug power cord is the dedicated EU mains-to-PSU cable for Whatsminer hardware deployed in continental European installations. C19 connector seats firmly into the Whatsminer PSU input socket; EU Schuko plug connects directly to standard CEE 7/4 mains outlets. 16A / 250V rated, matched to the Whatsminer PSU current envelope.

Built with 3x2.5mm² copper conductors — minimises voltage drop and resistive loss across the 1.5m run, important when running multiple miners off a single circuit. 1.5-meter length gives flexibility in setting up the rack without leaving excessive slack. Direct replacement for damaged or worn original cords and standard stock for new EU deployments.

When You Need an EU C19 Power Cord

• New Whatsminer deployment in EU installations — connect to standard Schuko mains outlets.
• Replacement of damaged original cord — burnt connector, cracked jacket, or melted plug after a fault event.
• Spare stock for mining-farm operations — keep replacements on the shelf for rapid swap on a damaged cord.
• Standardisation across EU fleet — replace mixed cord types with a consistent C19-to-Schuko reference.

Whatsminer EU Power Cord Specifications

FAQ — Whatsminer EU Power Cord

Q: Will this cord work in UK / Italy / Switzerland?
A: No — EU Schuko (CEE 7/4) is the standard for Germany, France, Benelux, Spain, Italy (with adapter), Eastern Europe. UK uses BS 1363, Italy native uses CEI 23-50, Switzerland uses SEV 1011. For other plug standards, choose the corresponding variant. We stock multiple regional plug types for Whatsminer C19 cords.

Q: 3x2.5mm² vs 3x1.5mm² — is the heavier gauge necessary?
A: For continuous mining duty at 16A, 2.5mm² stays well within thermal limits and minimises resistive loss. 1.5mm² runs hotter at the same current and adds voltage drop that can affect PSU regulation under load. Mining-grade cords should always be the heavier gauge.

Q: Can I use this cord on Antminer or Avalon PSUs with C19 input?
A: Yes — C19 is a standardised IEC inlet. Any miner PSU with a C19 input socket accepts this cord. Match the current rating to your PSU's input current envelope.

Q: Bulk pricing for EU mining-farm operators?
A: Yes — email contact@lys-sz.com for volume pricing on full-fleet cord stock.

Related products

• Whatsminer P21 Switching PSU 3300W (C19 input)
• Whatsminer C19 16A Power Socket (PSU repair)
• C19 Female Power Socket 250A (Mining PDU)
• C19 to C20 Power Cord 1.5m 14AWG 250V (PDU)

EU mining-farm operators stocking C19-to-Schuko cords in volume? Email contact@lys-sz.com for bulk pricing. Worldwide shipping from our Shenzhen warehouse.