Goldshell 18pin Data Cable 9×2p IO 10cm Miner

Goldshell 18pin Data Cable | 9×2 IO Cable for Goldshell & Antminer Series Control Board to Hashboard

The Goldshell 18pin data cable is the control-board-to-hashboard IO cable for Goldshell series miners and select Antminer models. 18 pins in a 9×2 configuration, 10cm length, built for reliable signal transmission between the controller and the hashboard chip chain. When this cable degrades or breaks, the miner reports the hashboard as missing even though the hashboard itself is fully functional.

Drop-in replacement when the original cable shows damage — bent pins, broken strain relief, or contact corrosion. The compact 10cm length fits the standard control-board-to-hashboard spacing in Goldshell chassis without leaving excess slack inside the miner enclosure.

When to Replace the 18pin Data Cable

• Hashboard reported missing even though the hashboard tests OK on a bench fixture — cable signal path broken.
• Intermittent hashboard drops — degraded cable connection under thermal cycling.
• Visible damage — bent pins on either end, cracked connector housing, or melted insulation.
• Standard refit during a full bench service — fresh cable eliminates the cable as a future fault source.

Goldshell 18pin Data Cable Specifications

FAQ — Goldshell 18pin Data Cable

Q: Which Goldshell models use this cable?
A: Used across multiple Goldshell series miners. Specific models vary — confirm by counting the pin pattern on your existing cable (9×2 = 18 pins is the match). Some Antminer models also share this 18-pin geometry; verify by physical inspection before ordering.

Q: Same cable as the Antminer 18-pin signal cable for Iceriver?
A: Often physically compatible but check pinout direction — some 18-pin cables are wired straight-through, others reverse certain signals. If you have a known-good cable, compare pin-by-pin continuity before swapping.

Q: Cable damage prevention?
A: Route cleanly inside the miner without tight bends or pressure points. Avoid pulling the cable from the wires — always pull on the connector housing itself. Cable lifespan is dramatically reduced by mechanical stress at the connector exit.

Q: Bulk pricing for repair benches?
A: Yes — email contact@lys-sz.com for volume pricing on data cable stock.

Related products

• 18-Pin Signal Cable 20/30/60cm (Antminer / Iceriver)
• Innosilicon Test Fixture Data Cable 14-pin 60cm
• Goldshell Test Fixture (HS5 / CK5 / CK6 / KD5 / KD6 / LT5)
• Goldshell LT5 Control Board

Goldshell / Antminer repair benches stocking 18-pin data cables in volume? Email contact@lys-sz.com for bulk pricing. Worldwide shipping from our Shenzhen warehouse.