AC Power cord C14 to C19 15A 250V - PDU to ASIC PSU
Couldn't load pickup availability
Have questions about this product? Our team is here to help — just reach out on WhatsApp.
💬 Contact Us on WhatsAppAbout the Product
AC Power Cord C14 to C19 1.5m 15A 250V for ASIC Miner / PDU Extension
This AC power cord is a heavy-duty extension cable that mates a C14 male plug on one end with a C19 female receptacle on the other, rated 15A at 250V AC. It is sized for ASIC crypto-mining devices, servers, switches and multimedia equipment that need a reliable C14-to-C19 link between PDU and PSU.
Built with 12/14AWG conductors over a 1.5 metre length, this cord delivers low voltage drop under sustained mining loads and provides the mechanical strain-relief required for permanent installation in a rack cabinet.
Specifications
| Parameter | Value |
|---|---|
| Model no. | C14 to C19 extension power cord |
| Category | AC heavy-duty power cord |
| Plugs | C14 male / C19 female |
| Current rating | 15A |
| Voltage rating | 250V AC |
| Conductor gauge | 12/14AWG |
| Length | 1.5m (5ft) |
| Condition | New |
| Applications | ASIC crypto miners, computers, servers, multimedia routers |
When to use a C14-to-C19 cord
The C14/C19 mating pattern is common on data-centre PDUs and on ASIC miner power supplies that accept up to 15A on a single input. Use a C14-to-C19 extension to feed a high-current PSU from a PDU outlet that sits outside the cabinet rail, or to link two short cords together to reach the miner. Always confirm the actual inlet/outlet pattern on your hardware before ordering.
Compatibility
Suitable for ASIC crypto miners, computers, servers, switches and multimedia equipment using the C14 inlet / C19 outlet pattern. For the reverse C13-to-C20 pattern used on many Bitmain Antminer PSUs, see the matching cord in related products.
Common failure symptoms
- Loose connector causing intermittent reboots under sustained mining load
- Visible burn marks or melted insulation around either end
- Voltage drop along the cord increasing under high current
- Cracked strain relief at the cord-to-plug entry
- Discoloured contacts from arcing inside the C19 receptacle
Frequently asked questions
Will it fit a rack PDU?
Yes if the PDU outlet is C19 and your miner PSU inlet is C14. Most 15A/16A rack PDUs match this pattern.
What is the maximum continuous current?
The cord is rated 15A at 250V. Size the upstream breaker and your installation accordingly.
Is it the same as a C13-to-C20 cord?
No — the C13/C20 pattern is the reverse and is found on many Bitmain Antminer PSUs. See our C13-to-C20 extension cord for that case.
Can I use it outdoors?
This cord is intended for indoor rack and equipment installations. Outdoor use needs an outdoor-rated cord.
Related products
- AC Power Cord C13 to C20 1.5m for Antminer Bitmain PSU
- Single P33 Plug AC Power Cord for Antminer T21
- P33-to-P33 AC Power Cord for Antminer T21
- Antminer Hydro PSU Cable for APW11 (S19/T19/S21 Hydro)
Contact contact@lys-sz.com for volume pricing or compatibility questions.
Buying in bulk for a mining farm or repair shop?
Get dedicated B2B pricing on this part and across our full catalog — quote response within 24 hours, payment by T/T USD bank wire, and DDP delivery available for US & EU customers (and other lanes on request).
