Whatsminer M20 M30 M50 Series Test Fixture Cable 16P to 22P

Whatsminer Test Fixture Cable 16P–22P – M20 / M30 / M50 Series Diagnostic Tool

This test fixture cable provides a direct 16-pin to 22-pin connection between the Whatsminer control board and hashboard for diagnostic and repair purposes across the M20, M30 and M50 series. It enables stable data transmission without adapter boards, simplifying the repair workflow when testing individual hashboards outside the miner chassis. Essential tooling for any shop servicing MicroBT Whatsminer hardware.

Why a Dedicated Test Cable Matters

When diagnosing a faulty hashboard, you need to connect it directly to a known-good control board to isolate the fault. The standard in-chassis data ribbon is too short for bench work and requires the full miner assembly. This test fixture cable bridges the 16-pin control board header to the 22-pin hashboard connector at a bench-friendly length, allowing you to power the hashboard independently and run chip scans, voltage checks and hash rate verification without the rest of the miner attached.

Usage

Connect the 16-pin end to the control board test header and the 22-pin end to the hashboard data connector. Power the hashboard through a bench PSU or the miner's PSU. Launch the chip scan or hash test through the control board's web interface. The cable carries all data, control and status signals needed for full hashboard diagnostics.

Test Fixture Cable Specifications

Related Whatsminer Test & Diagnostic Tools

• 14-Pin Test Fixture Cable – M20 / M30 / M31 / M32 / M50
• Signal Cable 14P–18P – M20 / M21 / M30 / M31 Test Fixture
• Whatsminer M20/M30 Test Fixture – Faulty Chip Scanner
• Whatsminer M30 / M50 ASIC Test Fixture

Equipping a Whatsminer repair bench? Contact us at contact@lys-sz.com for test cables, fixtures and diagnostic tooling.

Worldwide shipping from our Shenzhen warehouse.